Installation
ISC Big Brake Install 02-07 WRX
What comes in the kit!
1. Braided stainless brake lines
2. Caliper bracket
3. Caliper Bolts
4. ISC 6 piston Caliper pre loaded with pads
5. ISC slotted brake rotor
The Install
1. Remove wheel.
2. You will then need to remove the two 19mm bolts holding the caliper to the hub.
3. Support the old caliper with something while you install the new setup. This is what it should look like.
4. locate the new ISC caliper bracket and the two 19mm bolt you just removed.
5. Install the bracket so that the groove in it faces the engine side of the car. The 19mm bolts will install in the same location they were removed from on the old setup. It should look like this once you have it on.
6. Install the new ISC rotor and use a lug nut to secure it in place while you install the caliper. With the new rotor on it should look something like this.
7. Time to install the new 6 piston calipers. Make sure to remove the foam square that is keeping the pads separated. You will also need to get 2 of the black hex head bolts as well. Install the caliper and tighten the bolts down.
8. Now that you have the new setup in place you can swap the brake line over from the old caliper to the new one.
9. Now you will need to bleed the brakes to make sure that any air trapped in the system from the brake line change is out.
10. Once you have bled the brakes well and got all the air out it is time to put the wheel on and admire the new setup! The picture shown is with my 17×8 +45 wheels and no spacers.
For larger views of the images above see the “Brake Photos” page under the “Brakes” tab in the menu at the top of this page.
Leave a Reply
